Invacare Infinity Back Support Manual do Utilizador Página 1

INFINITY BACK SUPPORTSAssembly, Installation andOperation Instructions

10INSTALLING/REMOVING THE INFINITY BACKINSTALLING/REMOVING THEINFINITY BACK (FIGURE 1)NOTE: Refer to the INSTALLATION AND STABILITYWARNINGS in the SAF

11ADJUSTING THE INFINITY BACK PROCEDURE 4ADJUSTING THE HINGE/ANGLE(DUALFLEX ONLY)NOTE: Refer to the INSTALLATION AND STABILITYWARNINGS in the SAFETY S

12ADJUSTING THE INFINITY BACKPROCEDURE 4ADJUSTINGConverting Fixed Angle Hinges to DynamicFlex Hinges (FIGURE 3)1. Remove the four (4) short mounting s

13PROCEDURE 4ADJUSTING THE INFINITY BACKADJUSTING6. Slide one (1) lateral support to the desired location.7. Visually inspect the adjustment slot to

14PROCEDURE 5FIGURE 1 - REMOVING/INSTALLINGBACK CUSHION FOAM Top ofBackCoverBackCushionFoamBottomFlapINSTALLING/REMOVINGCUSHION FOAMNOTE: Refer to the

15PROCEDURE 5MAINTENANCEMAINTENANCEInstalling/Removing Adjustable PositioningPad (UNIBACK ONLY) (FIGURE 3)INSTALLING.1. Lift the top flap up and pull

Form No. 99-104 Part No. 1077719 Rev. A. (1)-3/99 Printed in U.S.A.INVACARE CORPORATION l ONE INVACARE WAY l P.O. Box 4028 l Elyria, Ohio 44036-2125Ph

2WARNINGTHE PROCEDURES IN THIS MANUAL MUST BE PERFORMEDBY AN AUTHORIZED DEALER OR QUALIFIED SERVICETECHNICIAN.DO NOT INSTALL OR USE THIS EQUIPMENT WIT

3SAFETY SUMMARYSAFETY SUMMARYSAFETYSUMMARYNOTE: Check all parts for shipping damage. In case of damage, DO NOT use. Contact your Dealer for further in

4SAFETY SUMMARYSTABILITY WARNINGS (CONTINUED)ALWAYS make sure wheelchair is stable BEFORE reclining the back system. Rear wheels mayhave to be reposit

5INSTALLATION/ADJUSTMENT OVERVIEW (FIGURE 1)WARNINGFor proper installation of the Infinity Back and to reduce the risk of pressure sores, theadjustmen

6PROCEDURE 1 PREPARING WHEELCHAIRPREPARINGWHEELCHAIRThis Procedure includes the following:Installing/Removing Cane ClampsInstalling InsertsINSTALLING/

7This Procedure includes the following:Installing/Removing the Lateral SupportsInstalling/Removing CushionsAdjusting the Mounting HardwarePREPARING TH

8PREPARING THE INFINITY BACK FOR INSTALLATIONTop FlapBottomFlapFastening Strips(Attach to Back Panel)InfinityBackFasteningStripsElasticStripREMOVING.1

9PREPARING THE INFINITY BACK FOR INSTALLATION4. If necessary, loosen, but do not remove the two (2)mounting screws securing each upper width bracketto