Invacare Force Manual do Utilizador descarregar pdf (Página 32)

SECTION 6—RIDING POSITION

Recumbent Handcycle Series 32 Part No 1114850

SECTION 6—RIDING POSITION

 WARNING

After any adjustments, repair or service and before use, make sure all attaching

hardware is tightened securely - otherwise injury or damage may result.

Replacing/Adjusting the Footrest and Leg Guard

NOTE:Forthisprocedure,refertoFIGURE 6.1.

NOTE:Ifreplacingfootrestorlegguard,takenoteofcurrentposition.

Replacing/Adjusting Footrest

1. Removethehexboltandlocknutthat

securethefootresttothefork.

2. Ifreplacingfootrestperformthe

following:

A. Removeexistingfootrestfrom

clamp.

B. Insertnewfootrestintoclamp.

3. Slidefootresttodesiredposition.

4. Reinstallhexboltandlocknut.Tighten

securely.

5. RepeatSTEPS1‐5fortheopposite

footrest,ifnecessary.

Replacing/Adjusting Leg Guard

NOTE:ThisprocedureisforTopEndXLT,

XLTJr.,andXLTProONLY.

1. Loosenthetwoallenscrewsoneach

mountingclamp.

2. Ifreplacinglegguard,preformthe

following:

3. Removeexistinglegguardfrom

clamps.

4. Insertnewlegguardintoclamps.

FIGURE 6.1 Replacing/Adjusting the

Footrest and Leg Guard

5. Positioneachmountingclampontotheforkunderthebrake

cable.

NOTE:Thelegguardshouldsurround,butnottouch,therearofthefronttire.

6. Adjustlegguardtodesiredposition.

7. Tightenthetwoallenscrewsoneachmountingclampsecurely.

Fork

Clamp, Hex,

Bolt and

Locknut

Footrest

Footrest Replacement/Adjustment

Fork

Brake Cable

Leg Guard Replacement/Adjustment

Allen

Screws

Mounting

Clamp

Leg Guard

Rear of

Front Tire

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 75 76

Comentários a estes Manuais

Sem comentários

Invacare Force Manual do Utilizador Página 32

Comentários a estes Manuais

Manuais e produtos relacionados com Comunicação Invacare Force