Invacare Force Manual do Utilizador descarregar pdf (Página 67)

SECTION 9—OPTIONS

Part No 1114850 67 Recumbent Handcycle Series

Using the Travel Ready Option

NOTE:Forthisprocedure,refertoFIGURE 9.14onpage67.

NOTE:ThisprocedureisforTopEndXLTPro,Gold,andTopEndForcemodelsonly.

Thetravelreadyoptionallowsthehandcycletobequicklyandeasilydisassembledfor

travel.

NOTE:Reversethestepsbelowtoreassemblethehandcycle.

1. Removetherearwheels.RefertoInstalling/AdjustingtheRearWheeland

Quick‐ReleaseAxlesonpage 42.

2. Removethecamberbar.RefertoRemoving/InstallingtheCamberBaronpage 67.

3. Removethefootrests.RefertoReplacing/AdjustingtheFootrestandLegGuardon

page 32.

4. Removetheforkandfrontwheel.RefertoRemoving/InstallingtheFork‐Travel

ReadyXLTPROEquippedwithRoadCrownCompensatoronpage 68or

Removing/InstallingtheFork‐XLTGold,andTopEndForceEquippedwithSteering

Dampeneronpage 69.

Removing/Installing the Camber Bar

NOTE:Forthisprocedure,refertoFIGURE 9.14onpage67.

NOTE:Toinstallthecamberbar,reversethestepsbelow.

1. Performoneofthefollowing

•AdjustableAngleSeatonXLTGold‐Seatsupporttubedoesnotmounttocamber

bar.ProceedtoSTEP2.

•AdjustableAngleSeatsExceptXLTGold‐Loosen,butDONOTremovethetwo

hexscrewssecuringtheseatsupportclampstothecamberbar.

2. Loosen,butDONOTremovethetwohexscrewssecuringtheframeclampstothe

camberbar.

3. Slidethecamberbarthroughtheclamps.

FIGURE 9.14 Removing/Installing the Camber Bar

Frame Clamp

Socket

Screws

Camber Bar

Seat Support Clamp

(Not Present on XLT Gold)

Socket

Screws

Seat Support Clamp

(Not Present on XLT Gold)

1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 75 76

Sem comentários

Invacare Force Manual do Utilizador Página 67