Invacare Force Manual do Utilizador descarregar pdf (Página 44)

SECTION 7—WHEELS

Recumbent Handcycle Series 44 Part No 1114850

Determining/Adjusting Toe In/Toe Out

NOTE:Forthisprocedure,refertoFIGURE 7.3.

Determining Toe In/Toe Out

1. Inflateallpneumatictirestorecommendedtire pressures(listedonthesidewallofthe

tire).

2. Measurethedistancebetweenthe

centerlinesattherearandfrontofthe

rearwheelsatapproximately12inches

fromtheground/floor.

NOTE:Foroptimumaccuracy,performSTEP

2withthehandcycleoccupied.

NOTE:Step2maybeperformedwithusing

alignmentgauge(availableasanoptionforthe

handcycle).RefertoUsingtheAlignment

Gaugeonpage 74.

3. Determinethedifferencebetweenthe

twomeasurements.Ifthedifference

betweenthetw omeasurementsis

greaterthan1/8‐inch(formaximum

rollability),oneoftwoconditionsexists:

•Ifthebackcenterlinemeasurement

oftherearwheelsissmallerthan

thefrontcenterlinemeasurementof

therearwheels,atoe‐outcondition

exists.

•Ifthebackcenterlinemeasurement

oftherearwheelsisLARGERthan

thefrontcenterlinemeasurementof

therearwheels,atoe‐incondition

exists.

4. Ifthedifferencebetweenthe

measurementsisgreaterthan1/8‐inch,

correctthetoe‐in/toe‐outcondition.

RefertoAdjustingToeIn/ToeOut

on

page 45.

FIGURE 7.3 Determining/Adjusting Toe

In/Toe Out

Smaller Than

Front

Larger Than Front

Front of handcycle

Toe-out

Toe-in

Top View of

handcycle

DETAIL “A”

Clamp

Camber Bar

Socket Screw

Camber

Insert

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 75 76

Comentários a estes Manuais

Sem comentários

Invacare Force Manual do Utilizador Página 44

Comentários a estes Manuais

Manuais e produtos relacionados com Comunicação Invacare Force