Invacare Force Manual do Utilizador descarregar pdf (Página 35)

SECTION 6—RIDING POSITION

Part No 1114850 35 Recumbent Handcycle Series

Adjusting Top End XLT Gold Hand Crank

NOTE:Forthisprocedure,refertoFIGURE 6.5.

Adjusting Hand Crank Height

1. Loosen,butDONOTremovethehexnutsecuringthehandcranktotheforkstem.

2. Loosen,butDONOTremovethetwosetscrewsfortheupperclamp.

3. Movethehandcrankassemblyupordownintheforkneckuntilyouarecomfortable

withthepositionforoperationalpurposes.

NOTE:Thehandcrankshouldbepositionedsothatwhenthehandistowardthefrontofthe

handcycle,thearmisslightlybent.ThearmshouldNEVERbefullyextended(locked)atanypoint

whilecranking.

4. Tightenthehexnuttosecurethehandcrankinthedesiredposition.

5. Tightenthetwosetscrewsontheupperclamp.

6. Tightenthechainifnecessary.RefertoAdjustingSev enSpeedHubChainonpage 55

orAdjustingTwenty‐SevenSpeedCassetteChainonpage 56.

FIGURE 6.5 Adjusting Top End XLT Gold Hand Crank

Hex

Nut

Fork Neck

Upper Clamp

and Set

Screws

Hand Crank

(Gear and Chain Not Shown)

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 75 76

Sem comentários

Invacare Force Manual do Utilizador Página 35