
SECTION 9—OPTIONS
Recumbent Handcycle Series 74 Part No 1114850
Using the Alignment Gauge
NOTE:Forthisprocedure,refertoFIGURE 9.19.
NOTE:Thealignmentgaugeisusedtodeterminetoein/toeout.RefertoDetermining/Adjusting
ToeIn/ToeOutonpage 44formoreinformation.
1. Inflateallpneumatictirestorecommendedtire pressures(listedonthesidewallofthe
tire).
2. Placethehandcycleandalignmentgaugeonaflatsurface.
3. Positionthealignmentgaugeneartherearofthereartires.
4. Loosentheheightadjustmentscrew.
5. Raise/lowerthealignmentbarsothebarisapproximately12inchesfromthe
ground/floor.
6. Tightentheheightadjustmentscrew.
7. Loosenthealignmentscrew.
8. Positionthealignmentgaugebetweentherearofthereartires.
9. Adjustthealignmentbarsothealignmentgaugefitssnuglybetweentherearofthe
reartires.
10. Tightenthealignmentscrewtosecurethealignmentbarposition.
11. Positionthealignmentgaugeatthefrontofthereartires.
12. Examinethegauge.Performoneofthefollowing:
A. AlignmentGaugeFitsSnuglyBetweentheFrontoftheRearTires‐Wheelsare
aligned.Notoein/toeoutadjustmentisneeded.
B. ThereisExtraSpaceBetweentheAlignmentGaugeandRearTires‐Thetireshave
atoeoutcondition.RefertoAdjustingToeIn/ToeOutonpage 45.
C. AlignmentGaugeDoesNotFitBetweenRearTires‐Thetireshaveatoein
condition.RefertoAdjustingToeIn/ToeOut
onpage 45.
FIGURE 9.19 Using the Alignment Gauge
Alignment Gauge
Alignment Bar
Height Alignment
Screw
Alignment Screw
Front of Handcycle
Rear Tires
Front Measurement
Rear Measurement
Rear of Handcycle
Comentários a estes Manuais